Wireless signal transmission (multichannel)for analog and digital inputs - with analog outputs HN-MS

570Hanwell MS1000 system modules can be used to take signals from any of the Hanwell wireless Radiolog series battery powered radio transmitters and convert them to analog signals which may be read by any BMS or DCS system or other instrumentation. It can also receive digital alarm signals and output them as relays.
Hanwell MS1000 system
The modules are 4 channel analog or relay, and multiple modules can be stacked on a DIN rail as a mixture of analog and digital signals, all linked on an RS485 bus to ONE RX receiver. 
The modules can alternately be added to a full DAQ system where some of the data [which is normally for Quality Assurance] may be needed for control or display by the plant operations group
The Hanwell 434MHz network has a range up to 3km and good performance in buildings and even from within enclosures.
Almost any measured variable input to remote battery powered data logging [100000values] radio transmitters
Multiples of 4ch outputs available at the receiving station as analog or relay signals
One RX receiver only required for many MS1000 modules.
Industrially hard product performance - REPLACE WIRING FOR DIFFICULT INSTALLATIONS
Use for emergency repairs to bypass wiring on a critical plant control loop on breakdown - fast and easy.

cost under $350 per loop in a 20 channel system
contact us for a system quote
Get More InformationGet Quote

Document Listing

Over viewSystem description and overview of connection
Data sheetBrochure MS1000 system